top of page

Order your horsehair jewellery

Woven horse hair ribbon bracelet - Crinoline, wide

£385.00
Woven horse hair ribbon bracelet - Crinoline, wide
Hair
Horse name for presentation card (Couture only)
Enter your text
Metal
Finished length (recommended wrist size + 2cm)
Add sliding ingot(s)
Personalise (add engraving text below)
Engraving text (be case specific) Relevant engraving option above must be selected.
Enter your text
Special Instructions (design requests, finished length if “Other”, requested deadline if possible)
Enter your text
Please supply clean hair (for Couture orders)
Delivery of horse hair
How did you hear about The Burnished Horse?
In stock
1
Save this product for later
Share this product with your friends
Woven horse hair ribbon bracelet - Crinoline, wide
Product Details

Hand woven horse hair ribbon bracelet, with a nod to British tailoring fabrics

The Crinoline is plain with no pattern and can be made either from single hair colour or by blending different hair colours which gives a repeating, mottled effect. "Crin" is of course French for "horse hair" and traditionally horse hair was woven into a stiff fabric, called "crinoline", which was used to stiffen ladies' underskirts and dress linings.

9 mm woven horse hair band set in an elegant flat clasp in burnished silver and bearing the distinctive TBH horse head logo. Hallmarked for quality by the London Assay Office and beautifully gift boxed including a presentation card with the name of the horse(s). Optional sliding ingot. Optional engraving.

Hand made to order Couture using your own horse's hair or Ready to Wear using hair that we provide.

We also cast in yellow, white and rose gold and in platinum. Metal prices are subject to fluctuation; please email for a quotation.


Details & Options

Horse hair: Full length tail hair is required for all woven pieces, regardless of finished length, because the hair must be long enough to fix on the loom. Slightly less than a little finger’s width of full length hair, 40 - 45 cm, is enough to make this bracelet. We always return any unused hair but it must fit in our envelopes so please don’t send more than needed as the excess will be discarded.

Measurements: We suggest a finished length of 2 cm greater than your wrist measurement. So if your wrist measures 16 cm, a good finished length would be 18 cm.

Please measure your wrist closely just above your wrist bone (arm side). We will make your jewellery to the length/size stated in the order. Correct measurement is vital because the horse hair is permanently glued into the clasp. Bracelets cannot be lengthened. They can potentially be shortened by a minimum of 1 cm but this would incur a charge.

Fastening: Your bracelet comes with a lobster clasp.

Engraving: on the outside of the ingot, if included, or discreetly on the inside of the clasp.

Timescale: All our jewellery is truly hand made and so timescales depend on order levels. Typically it takes around 4 - 6 weeks. Please email us beforehand if you have a particular deadline and we will try to accommodate you.

Please look after your jewellery!

As much as you love it, horse hair jewellery is not unbreakable and if you “love it too much”, your jewellery may not last! The better you care for your horse hair jewellery, the better it will last you.

Always follow the care instructions. In particular avoid prolonged soaking and anything that might snag, cut or abrade the horse hair. Please read our warranty. Failure to follow our care instructions excludes our warranty.

bottom of page